CCNA Routing and Scaling

1. What is one difference between using Telnet or SSH to connect to a network device for management purposes? • Telnet uses UDP as the transport protocol whereas SSH uses TCP. • Telnet does not provide authentication whereas SSH provides authentication. • Telnet supports a host GUI whereas SSH only supports a host CLI. • Telnet sends a username and password i

IT CIST | 2453 | CCNA Routing and Scaling | study guides | 1. What is one difference betw

Missed this queson? See below for some assistance! Refer to curriculum topic: 5.1.2 OSPFv3 is used for IPv6 roung. When the default route is redistributed, neighboring routers will display the route source as OE2 in their IPv6 roung tables. The show ip route command is used to display the IPv4 roung table. The default-informaon originate command is u

IT CIST | 2453 | CCNA Routing and Scaling | study guides | Missed this queson? See below

Missed this question? See below for some assistance! Refer to curriculum topic: 5.1.2 Missed this question? See below for some assistance! Refer to curriculum topic: 5.1.2 Question 1 What is one reason to use the ip ospf priority command when the OSPF routing protocol is in use? • to activate the OSPF neighboring process • to inﬂuence the DR/BDR election pro

IT CIST | 2453 | CCNA Routing and Scaling | assessment | Missed this question? See belo

1. Which statement describes the port speed LED on the Cisco Catalyst 2960 switch? • If the LED is green, the port is operating at 100 Mb/s. • If the LED is oﬀ, the port is not operating. • If the LED is blinking green, the port is operating at 10 Mb/s. • If the LED is amber, the port is operating at 1000 Mb/s. 2. Which command is used to set the BOOT environment variable t

IT CIST | 2453 | CCNA Routing and Scaling | study guides | 1. Which statement describes t

Chapter_2_Test_A.docx.docx-What are two advantages of static

All courses in IT CIST

Popular Documents