CCNA Routing and Scaling

Networking

1. A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.) • lower bandwidth requirements • reduced cost for equipment and user training • easier to provide redun

IT CIST | 2453 | CCNA Routing and Scaling | study guides | 1. A network designer must pro

1. Which statement describes the port speed LED on the Cisco Catalyst 2960 switch? • If the LED is green, the port is operating at 100 Mb/s. • If the LED is oﬀ, the port is not operating. • If the LED is blinking green, the port is operating at 10 Mb/s. • If the LED is amber, the port is operating at 1000 Mb/s. 2. Which command is used to set the BOOT environment variable t

IT CIST | 2453 | CCNA Routing and Scaling | study guides | 1. Which statement describes t

chapter_3.docx.docx-User Course CIST2611: Network Defense &

Chapter_2.docx.docx-Review Test Submission: Chapter#2 Test User

Missed this queson? See below for some assistance! Refer to curriculum topic: 5.1.2 OSPFv3 is used for IPv6 roung. When the default route is redistributed, neighboring routers will display the route source as OE2 in their IPv6 roung tables. The show ip route command is used to display the IPv4 roung table. The default-informaon originate command is u

Schools|Augusta Technical College

Departments in Augusta Technical College

IT CIST

IT CIST

NET

NET

Popular courses from Augusta Technical College

Popular documents from Augusta Technical College